WARNING: To avoid overheating, do not cover the heater.
1. If the power cord is damaged, it must be replaced by the manufacturer, at an authorized service center or by qualified persons in order to avoid a hazard.
2. The heater may not be placed directly under a power socket.
3. Do not use the same socket together with other electrical appliances to avoid overloading. Ensure that the plug and socket are firmly connected.
4. If the appliance is switched off, pull the plugs out of the sockets without pulling the wires.
5. If the heater breaks down or the wires are broken, disconnect the power supply immediately. Users cannot repair heaters by themselves. In the event of a fault, contact the authorized service department for maintenance.
6. The heater cannot be placed directly under an electrical outlet.
7. The surface temperature of the heater is very high. Therefore the heater must be installed at a height of more than 2.2 metres above the floor.
8. DO NOT COVER the surface of the heater and do not place any objects on it.
9. The distance between the back of the heater and the ceiling must be more than 150 mm, no objects may be placed less than 1000 mm below the heater and a distance of at least 200 mm must be maintained to the side.
10. Switch off the power and wait until the heater is completely cold before cleaning it. It is absolutely forbidden to wash the heater with water.
11. Users may not repair the heater themselves. In the event of a fault or for extraordinary maintenance, contact the authorised service department.
12. Do not install and use the unit in easily flammable or explosive areas.
13. Do not insert metal or other foreign objects inside the heater to avoid accidents or personal injury.
14. Radiant heater with high surface temperatures from >50 and #8451;~386 and #8451;: forbidden to touch, beware of accidental burns
15. To avoid accidents do not spray water into the radiator.

2. INTRODUCTION
Thank you for choosing our radiant heating system. Please read the instructions carefully before using the product and on how to install the heater

3. PRINCIPLE OF OPERATION

The infrared heating panel is characterized by unique design and special manufacturing techniques for its realization.
Using an aluminum panel with special coating, the heat emitted from the surface of the radiant panel is diffused by radiation and transferred to people, walls, floors, ceilings, furniture, etc. as if it were sunlight.
In contrast to traditional convection heating systems, infrared heating does not involve air flow. This keeps the air in the room cleaner because dust and particles do not enter the airstream.
The air stays less humid and gives a comfortable feeling of warmth similar to the warmth felt on a sunny day.